bellett.net
https://bellett.net/forums/

Twin cam inlet manifolds
https://bellett.net/forums/viewtopic.php?f=6&t=3230
Page 1 of 1

Author:  Gunna [ Sun Feb 14, 2016 9:02 pm ]
Post subject:  Twin cam inlet manifolds

I want to buy a set of inlet manifolds for the G200w twin cam motor. New, old or replica doesn't matter. Anyone?

Author:  Glenn [ Sun Feb 14, 2016 10:21 pm ]
Post subject:  Re: Twin cam inlet manifolds

Gunna wrote:
I want to buy a set of inlet manifolds for the G200w twin cam motor. New, old or replica doesn't matter. Anyone?


Maybe what type though Dean? Webers, SU's ? anything?

I have no idea if this might work but in the spare Sport, there is a inlet manifold on the floor.... maybe can be modded.

Author:  Gunna [ Sun Feb 14, 2016 11:05 pm ]
Post subject:  Re: Twin cam inlet manifolds

Glenn wrote:
Gunna wrote:
I want to buy a set of inlet manifolds for the G200w twin cam motor. New, old or replica doesn't matter. Anyone?


Maybe what type though Dean? Webers, SU's ? anything?

I have no idea if this might work but in the spare Sport, there is a inlet manifold on the floor.... maybe can be modded.


The plan is to trial the replica webers which are sold on fleabay but I need a set of manifolds to suit.

Thx Glenn, I'll dig around the SS (Spare Sport) when I finally get it off the trailer onto hard ground.

Also, Peter A found a single carby and manifold to suit the 1800 motor, so I have that option to leave in the motor in the SS.

D

Author:  gt orphanage [ Sun Feb 14, 2016 11:25 pm ]
Post subject:  Re: Twin cam inlet manifolds

I will see what I can do. I had a mould made of them a few years back the old bloke that did them was not well for a while. I promised Gricey I would get a set made and he reminded me on the weekend. I will see if he is up for a few sets both my twin cams are running these manifolds.

Author:  Gunna [ Sun Feb 14, 2016 11:35 pm ]
Post subject:  Re: Twin cam inlet manifolds

Thx Mr. GT

I'll be after 5 sets if it goes ahead. 2 for me, 2 for a friend and a spare if Wendy goes ahead we her project.

D

Author:  F3ARED [ Mon Nov 14, 2016 2:53 am ]
Post subject:  Re: Twin cam inlet manifolds

Did this end up going ahead? Im after a set too. Soft-mount versions are available ex-yahoo japan but arent really suitable for what i need.

N-

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/