bellett.net
https://bellett.net/forums/

Gt exhaust manifold faceplate
https://bellett.net/forums/viewtopic.php?f=6&t=3468
Page 1 of 1

Author:  claws [ Sat Jul 29, 2017 12:04 pm ]
Post subject:  Gt exhaust manifold faceplate

Has any one got one they can sell me, i need to get some extractors made. I know there was a bunch of them made somewhere on bellett.net a year or two ago. PM me

Cheers Craig

Author:  Stickman [ Sat Jul 29, 2017 11:24 pm ]
Post subject:  Re: Gt exhaust manifold faceplate

That was about 4 years ago when they were made and I believe (early 2013 maybe) they were only made in the numbers for those who put their hands up and put money forward at the time. Plenty said they were keen but only a few put their hands in their pockets.
All long gone now.
Any decent exhaust shop could make one for you though if you have a std manifold to make a template for the faceplate from.
I got a set done for one of my sedans from scratch a while back, cost me about $700 inc new muffler and exhaust to rear.

Author:  67GT [ Sun Jul 30, 2017 12:17 am ]
Post subject:  Re: Gt exhaust manifold faceplate

Hi Craig, Sticky's right, I had one made from scratch to suit the Florian head on my Wasp. The whole lot cost me $800.
If you have one already, just blown out like my GT one, it should be a lot cheaper. They can simply make new pipes to fit your mounting face. Laser cutting the mounting plate is where the cost goes up.

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/