bellett.net

WARNING some of these lenses were ordered and paid for at 2017 nationals and still not REcieved even after several phone calls.

The nissan floats are hitachi supplied same as bellett.,and have worked perfectly in our GT since it was put on the road.I have no doubt ,they are the modern replacement for the original ones.LINDSAY.

I have part no,s for replacement floats for original GT carbys.They are available through nissan parts X melbourne part no. 16061-k1407. They are a direct replacement for the old brass ones,most of witch are cracked and leak,almost impossible to repair permanetly.We have used them in our GT for the ...

Perhaps everyone should cool it .Would expect most nominations will only arrive a couple of weeks before closing date,and that is nearly 10months away. Give steve & peg a break.

Yes i have converted one , all you have to do is swap selector rods and forks.(on all syncro box) hope this helps.

Are any QLD,ers attending,I am if weather permits

Sorry for the late reply.They are the correct kits for a GT as i have recently fitted one to one of our GTs. A kit does both calipers,consists of 4 seals ,4 boots and a satchel of rubber grease. I would be intrested in a kit if you have one spare.lindsay

More pics

Attended the recent All Jap Day at Banyo and the bloke in the red shirt arrived in his restored Mazda RX2 Coupe. See pictures below

i will have a set here. lindsay

Attached are the other photos including Mazda B360 pickup, Toyota Tiara? Now for your photos from Murphy's Creek.

Good day was had by all at the All Jap Day. No I didn't win any trophies this time around. There were only two Bellett GT's present and two Gemini coupes representing the Isuzu make. But there were plenty of other makes including a Yamaha 100 twin motorcycle, Mazda 1000 coupe from Toowoomba Swap ...

all japanese classic day. 19.th.february. venue earnshaw state college. banyo. brisbane.

stinger will be home for christmas, thanks to bellett friends.

autobox should have switch on side ,either flat or round with four terminals,two for revurse & two for neutral & park . the auto wiring harness has the four wires along the rear of motor,hope this helps

i would suggest it comes out of another car

auto box in bellett doesn't have cooler in radiator. it has a vented bell housing. will check wiring in the daylight and report back later

maybe it,s the v8 under the bonnet.

diff. ratios . sedan & gt. numbers stamped on housing under filler plug vertical raised section no,s should be 10-41(4.1) 11-41(3.72) 9-34(3.77) and possibly9-37(4.1) two of my diffs have only 1-41. assume these are 4.1 ratio hope this info is helpful

We are ok. The Belletts are safe. Our house and workshop are high and dry. Can still get into work via the Bruce Hwy. The mighty Mary River has gone down a little but we still have the water from Gympie to come yet. They expect the river to go up a little again.