bellett.net

Does anybody know the isuzu part number for a full g180ss gasket set?

I have this type sump. Or does anyone know what other dipstick would fit this sump? One i could cut down to suit that will just fit the tube

hey guys im after a g200w or g180w dipstick if anyone has one spare. thanks

no real pics yet...the only difference from a few years back to now is i finally got a really good windscreen installer to install my windscreens with brand new rubbers and succesfully install the chrome trims..i will take some photos of the front end once i have installed the new front grille and ...

thanks guys! i have a heap of old hexagonal tail lights if anyone needs them...(around 12 of them i think) lenses are good chrome not so good. and a heap of windscreen chrome

hi does anybody have a part number for a chrome bellett boot lock. or even an un-pitted boot lock that i could use to get re-chromed?

cheers

does anybody know the part number for the 2 black rubber parts that bolt to the front of the chrome bumper bar?

davo's a bloody legend

im after a set of headlight buckets that have the brackets on them to mount the center grille. mine dont have these 2 brackets.

cheers

not to far away..

Just chasing if anyone has a new set of side indicators that screw to the gaurds

ok so i have found it super tough trying to put the chrome back into the windscreen rubber. Do you normal slide the chrome in from one end and around the corners or do you place the chrome on top of the rubber then fold the rubber holding edge in the chrome with a flat screwdriver or something?

hey guys does anyone have a picture of the outside door weatherstrip that sits against the glass window? I have 2 new original bellett strips but they dont fit very well...they sit about 5mm off the window so it doesnt seal. Is there a certain seal i can buy somewhere that works well?

hey guys what bailey channel rubber do you use. I bought some from the rubber shop in qld and it was to thin (the window just flopped around in the rubber)

cheers

aha! that would be because mines still in restoration mode...and will be for another few years id say..the only time it has been out was to get the hood lining done and the paint job..but that was on the trailer

ohhh i live right near this!!! i drove past this paddock a few times and way down the back i could make out this car and was like that looks like a 4 door teardrop...i was going to get the binos and get a better look but i knew it was one...i was going to post it up here that i found one in a ...

just comparing the pics it looks like a goer!! just need to use the front spline part that the tailshaft bolts too!

hang on a minute! my bellett crown wheel look the same the bellett has 41 teeth the only thing is the pinion gear..but when i looked at mine the bearing runner is pressed on so its not part of the pinion shaft itself..can you measure exactly how long the pinion gear is and also the thickness of the ...

just checked and the pinion gear is slightly differant...it has like a differant bearing holder

wow awesome pics mate damn looks so similar ill have to go up in the shed and take a look at the pinion gear tomorrrow and let you know! but looking at it right now it looks damn much the same!