Bellett gt hood lining

Waldo · Post by **Waldo** » Wed Jul 04, 2012 8:56 pm

Can anyone tell me what type of material is used for a stock bellett hood lining? A photo would be real handy that shows the texture

Glenn · Post by **Glenn** » Wed Jul 04, 2012 10:00 pm

not much help really except to say that the original style material was avaialble here, when i did my last GT.

glenn

1968GT · Post by **1968GT** » Sat Jul 07, 2012 9:44 am

Hey Waldo,
Since I have Glenns GT he last restored, I will try to get a photo for you.

I will try to get it up ASAP.
Regards,
Dave M.

1968GT · Post by **1968GT** » Fri Jul 27, 2012 5:22 am

Waldo,

SORRY, I have let you down with these photos, I will try to remember on Sunday as I won't be home until Sunday.
I have been working on the GT repairing brakes and still I forgot, you know what it is like as you get older :lol:

Geeshh! shouldn't admit to that eh!!!

I will post the photos on Sunday.

Dave M.

Glenn · Post by **Glenn** » Fri Jul 27, 2012 5:59 am

Dave

re the leak you have... there's a post on here somewhere with a seal for the master cylinder to reservoir......

glenn

Guys does anyone know where I can get some rubbers to fit between the master cylinder body and the reservoir.
The original rubbers on my master had perished and I have tried both brass abd fibre washers, but still have a leak between the two.
Would plumbing rubbers as used in toilet fittings etc work or would the brake fluid stuff them? Cause I reckon there would be a size to fit in the local plumbing supplies joint.
Somebody please help turn my frown upside down

Reply with quote
Post Re: fitting sigma discs to bellett
Try PBR kit K7308X Boot should fit

flying · Post by **flying** » Mon Jul 30, 2012 5:14 am

Waldo

bit dirty but I beleive original

1968GT · Post by **1968GT** » Mon Sep 10, 2012 3:56 am

WALDO,

Yep I KNOW bloody SLACK, ooops sorry :oops:

, try these photos, not sure what vinyl grain you can see but these are of the material Glenn used in the roof lining in the GT I have now!
There are 5 ribs, equally distanced between each bar.

I hope these are of assistance of not TOO LATE!!!

Dave M.