Page 2 of 2
Re: Urethane Rubber components ie timimg chain Damper
Posted: Thu Dec 15, 2011 3:33 pm
by 65bellett
Cheers for the Heads Up Gt. I just had a look at Phils E-bay store and he doesn't seem to have them listed, I will send him a message tomorrow. Do you know what series Luv they were from.
Sorry to Hi Jack the thread
Re: Urethane Rubber components ie timimg chain Damper
Posted: Wed Dec 28, 2011 8:58 pm
by Antti Pellonpää
Original timing chain tensioner rubbers are still available from Isuzu Motors. We have some stock here in Finland. But they cost 35 euros each.
Happy and Great New Isuzuyear 2012!
Re: Urethane Rubber components ie timimg chain Damper
Posted: Mon Oct 29, 2012 1:29 pm
by PR91
hey OZ....
anymore developments on the chain rubbers?
reckon i'm in need of one for sure....
Re: Urethane Rubber components ie timimg chain Damper
Posted: Mon Oct 29, 2012 9:32 pm
by Glenn
Antti Pellonpää wrote:Original timing chain tensioner rubbers are still available from Isuzu Motors. We have some stock here in Finland. But they cost 35 euros each.
Happy and Great New Isuzuyear 2012!
Dick, do you have a part number for them please?
glenn
Re: Urethane Rubber components ie timimg chain Damper
Posted: Mon Oct 29, 2012 9:36 pm
by oz_toffa
i have some that cured really well but not tested as yet.
really prefer to trial one in my own motor first, have a 1500 sedan motor coming together at moment but daughter wedding has slowed up the engine build.
if your real keen, you can trial one, but dont want to see your engine have issues, not that i imagine it wont be as good or better then the original ones.
OZ
Re: Urethane Rubber components ie timimg chain Damper
Posted: Wed Oct 31, 2012 9:00 pm
by Dick
To answer the question of Glenn;
the part nr of the rubber chain tensioner is 11319-051
groetjes Dick
Re: Urethane Rubber components ie timimg chain Damper
Posted: Thu Nov 01, 2012 7:53 am
by oz_toffa
Re: Urethane Rubber components ie timimg chain Damper
Posted: Fri Nov 02, 2012 10:17 pm
by oz_toffa
Has anyone used Hillman tensioner before?
i think i did fit one many years ago. they are about 116mm long and the original Bellett is 140mm. shape is exactly the same. can also get the metal spring to fit the Hillman size too.
only issue i can see is the tensioner may not do the job for as long as it wont give the chain quite the same area of load which would be ok when new, but as the chain stretches and wears, would get noisy sooner.
any and all thoughts will be considered as constructive :0
OZ
