bellett.net

Sway bar end rubbers:-

anybody got a source for these.

One of the most common rubbers to wear out on a Bellett. In the past I had NOS parts but they are long gone.

This must be a prime candidate for getting repro parts made as a group.

also, those rubbers on top of the inner mount link. The 'flat' ones onto the front cross member. I have seen something similar on a Fairlane in the past.

glenn

On the subject of rubbers, the rear spring end rubbers....

what top use there.. these ones look pretty far gone for example !

hi glenn i went to the local muffler shop he sored thru his bits and came up with a exaust holder virtually identical cut it in half and had 2 a bit of a trim will try and photo this w/e cheers davo remember im a muso ....

OK, thanks Dave

I am guessing there are lots of suitable rubbers that can be adapted etc for the car.

pedders make universeal ones in urethane/nolathane.
inner sedan ones are part# EPH18. GT are different as they are a couple of mm thicker in the bar, but i can't remember the exact size or part# atm... but i think they are 21mm. i'll check when i'm near my GT again.
outer ends are all the same, part# EP3320/15.

is that outer number a Pedders number ???

Inner one for GT i think used a HK ? Holden one years ago now. In Nolathane.

yep, sure is.
pic on my phone of them is still in the pedders packaging.

Are the pedders sway bar rubbers black or other colors?
Don't look quite original with red clamped in around the bar. Rather make my own in black!

Its everyone to their own I guess.

OZ

pedders are red, same as nolathane.
there was one mob doing black (whiteline i think) but it was only a few bushes at the time.

original on the left, home made Urethane on the right


OZ

great job done there mate .....who can tell the difference .......cheers davo

nice work oztoffa they look good!

anyone got an original new end rubber for the sway bars? or 2?

happy to pay postage and return it once i have made the mold.

need to borrow it for a week or so

happy to provide a few new Urethane pieces as payment for the loan.

PM me please if you can help out

did think i still had a few but must have used them all up....



Thanks

OZ

Oz

How are you going with the End Rubbers

I pulled mine out the other day one is still in good nick

Let me know if you can use it

Cheers

Love to borrow it, Flying

would you like a full set back as payment?

PM me for address details etc.


Cheers


OZ

I would certainly like to buy a couple of sets if you selling them OZ
Cheers Geoff

not sure if these might fit but since you guys are up that way, worth a look ?
http://www.ebay.com.au/itm/251097351905 ... 1423.l2649

$10 / pair

Hi Oz, sorry I'm slow to read this post. I have a couple of genuine NOS outer rubbers still in the pack if you would like to borrow them.
Or was Flying's good enough?

Great job on the repros mate,
Cheers, Matt.

Two newbies in the mail Oz, hopefully there early in the week.
Have fun!

Cheers, Matt.

thanks very much, Farmer.

get themback your way as soon as i make up the mold.

cheers

OZ