bellett.net

Can anyone tell me what type of material is used for a stock bellett hood lining? A photo would be real handy that shows the texture

not much help really except to say that the original style material was avaialble here, when i did my last GT.

glenn

Hey Waldo,
Since I have Glenns GT he last restored, I will try to get a photo for you.

I will try to get it up ASAP.
Regards,
Dave M.

Waldo,

SORRY, I have let you down with these photos, I will try to remember on Sunday as I won't be home until Sunday.
I have been working on the GT repairing brakes and still I forgot, you know what it is like as you get older
Geeshh! shouldn't admit to that eh!!!

I will post the photos on Sunday.
Dave M.

Dave

re the leak you have... there's a post on here somewhere with a seal for the master cylinder to reservoir......

glenn


Guys does anyone know where I can get some rubbers to fit between the master cylinder body and the reservoir.
The original rubbers on my master had perished and I have tried both brass abd fibre washers, but still have a leak between the two.
Would plumbing rubbers as used in toilet fittings etc work or would the brake fluid stuff them? Cause I reckon there would be a size to fit in the local plumbing supplies joint.
Somebody please help turn my frown upside down


Reply with quote
Post Re: fitting sigma discs to bellett
Try PBR kit K7308X Boot should fit

Waldo

bit dirty but I beleive original

WALDO,

Yep I KNOW bloody SLACK, ooops sorry , try these photos, not sure what vinyl grain you can see but these are of the material Glenn used in the roof lining in the GT I have now!
There are 5 ribs, equally distanced between each bar.

I hope these are of assistance of not TOO LATE!!!
Dave M.