bellett.net

IMG_20221212_172106957_2_1_1.jpg GT Front Disc Rotors

For some time now, I have been investigating replacement rotors for my GT which were getting down to the minimum limit, for the second or third time. The plan was to be able to use the existing GT hubs and callipers to avoid using parts from ...

Hi Dick,
Sorry about the delay in replying to your post - I only saw it recently when you sent the email.

I would like to get a new water pump. The 1600GT engine is OHV, and have found a couple of old corroded pumps in my collection of stuff that should be discarded. Your new pumps have 2 securing ...

Hi Dick,
A new spare water pump for my G161 engine would be good (it's the same as the G160 I think???).

Thanks, Barrie.

You're right Peter, it is this flange. Taking out the swing arm is the last resort I guess, not something I wanted to do yet. I will persevere with dripping the acid/acetone mix onto the end of the spline several times a day for a while and try the bearing puller again or the house levelling jack ...

Hi Dean,
I've nearly finished the process of rebuilding the diff on the GT, and thought about checking the rear wheel bearings. Just as well - there's a bit of wobble in the axle shaft, so the bearings definitely need replacement after about 350,000 km and over 50 years!!!!
Do you still have 2 of ...

What is the thickness of the gaskets you have?? And are they mainly cork like what GTtoo had or a more rubberised cork material?
Cheers.

Hi all and GTtoo -

I am chasing a gasket for my GT to fix a bad oil leak - old one has distorted and moved and is a mess.
Auto Surplus in Mitcham have 2 made from cork, but seem to bee very thick at about 5-6mm and also a tad expensive ($45 !!!!).
Glenn gave me a link to GTtoo from a couple of ...