Page 1 of 1
compliance plate or chassis number location
Posted: Wed Apr 16, 2014 10:56 am
by robot__
Hi All,
Anyone know if the Wasps had a compliance plate or where I may find a chassis number on my Wasp?
Re: compliance plate or chassis number location
Posted: Wed Apr 16, 2014 11:48 am
by dave
Heya Robot,
The Wasp has a chassis number stamped on the chassis crossmember located approximately under where the passenger would sit.
I had to attack mine with a wire brush for several minutes to get mine to show up, and mine actually isn't that bad underneath!
They also have a little build plate in the engine bay on the side; can't remember if it's on the driver's or passenger side!
They don't really have much useful info printed there; just the engine and chassis # from memory, as for build date, who knows?!?!
The Wasps were all imported in 1965 I've been told, so it's probably a 1965! FYI there were only 122 of them sold here, so they're a rare beast!
Welcome to the forum!
Cheers,
Dave
Re: compliance plate or chassis number location
Posted: Wed Apr 16, 2014 10:46 pm
by robot__
Cheers Dave,
I shall grab a wire brush from work today and see how I go
Re: compliance plate or chassis number location
Posted: Fri Apr 18, 2014 7:27 am
by PR91
Reply in your thread in the 'my bellett' section as well.