Water problem
-
gricey
- Posts: 692
- Joined: Wed Feb 24, 2010 9:37 pm
- Car(s): 2 GT Belletts bellett sedan . Florian.gt project.fj Holden. Gemini.lc gtr.datsun240 z
Water problem
Looks like my red gt has started to use water. Does not appear to be leaking. Any one give a heads up on ware to start looking. Gricey
- redback
- Posts: 524
- Joined: Sun Oct 05, 2008 10:21 pm
- Car(s): Isuzu Bellett, VG Commodore Ute, Custom Chopper
- Location: Darwin NT
- Contact:
Re: Water problem
Could be a head gasket - any water in the oil. Is it steaming out of the exhaust pipe??
-
gricey
- Posts: 692
- Joined: Wed Feb 24, 2010 9:37 pm
- Car(s): 2 GT Belletts bellett sedan . Florian.gt project.fj Holden. Gemini.lc gtr.datsun240 z
Re: Water problem
Oil is ok and no stem . Gricey
Re: Water problem
if it's only a very slight leak from the head gasket u won't get steam tho.
are u sure it's a 'leak' tho? i've seen them get a gut full of air in the system from not being totally full and it's creates an air lock. then when it's running the lock releases and the air goes to the top so the water level looks low when u check it again making u think ur losing water.
just a thought.
are u sure it's a 'leak' tho? i've seen them get a gut full of air in the system from not being totally full and it's creates an air lock. then when it's running the lock releases and the air goes to the top so the water level looks low when u check it again making u think ur losing water.
just a thought.
-
gricey
- Posts: 692
- Joined: Wed Feb 24, 2010 9:37 pm
- Car(s): 2 GT Belletts bellett sedan . Florian.gt project.fj Holden. Gemini.lc gtr.datsun240 z
Re: Water problem
Thanks Brett. Rolling that idea also I have replaced the cap. Ran it and found it threw out the over flow. Gricey
Re: Water problem
is exactly what my old 351 falcon did too.
basically got hot enuf to push water out the overflow and made it worse coz u couldn't keep it cool due to the air lock.
I'd run it without the cap on, let it warm up completely at just slowly top it up till it can't take anymore.
see how u go then coz that should get rid of any lock.
oh and make sure the heater is on full hot too coz if that's empty it'll make another lock when it's turned on again.
basically got hot enuf to push water out the overflow and made it worse coz u couldn't keep it cool due to the air lock.
I'd run it without the cap on, let it warm up completely at just slowly top it up till it can't take anymore.
see how u go then coz that should get rid of any lock.
oh and make sure the heater is on full hot too coz if that's empty it'll make another lock when it's turned on again.
-
gricey
- Posts: 692
- Joined: Wed Feb 24, 2010 9:37 pm
- Car(s): 2 GT Belletts bellett sedan . Florian.gt project.fj Holden. Gemini.lc gtr.datsun240 z
Re: Water problem
Good advice Brett I will get at it to day. Gricey
- redback
- Posts: 524
- Joined: Sun Oct 05, 2008 10:21 pm
- Car(s): Isuzu Bellett, VG Commodore Ute, Custom Chopper
- Location: Darwin NT
- Contact:
Re: Water problem
Heater?
Oooh that's right it is cold down south.....heh heh
Oooh that's right it is cold down south.....heh heh
- Farmer
- Posts: 2591
- Joined: Tue Oct 28, 2008 12:17 pm
- Car(s): Doris, AuntyMary, Shrek, Jimmy; GT, Wasp, Flo & Sed unrestos; 65 Elf; 82 Rodeo, 60 TX550, 72 Sport, & a Sigma.
- Location: Rye Park, N.S.W.
Re: Water problem
Hey Gricey,
I've fitted a recovery bottle to the Florian because every time the motor warms up it pushes some coolant past the cap through expansion. Just find a bottle that fits (A Triton ute one for Mary), connect the tube from the overflow & fit a recovery type cap. (Make sure it reaches the contact plate - The throat is deep.) As it cools down, it sucks the liquid back.
Wow, all moderny!
This prevents the green wee or rusty mess, depending what you run in there.
Cheers, Matt.
I've fitted a recovery bottle to the Florian because every time the motor warms up it pushes some coolant past the cap through expansion. Just find a bottle that fits (A Triton ute one for Mary), connect the tube from the overflow & fit a recovery type cap. (Make sure it reaches the contact plate - The throat is deep.) As it cools down, it sucks the liquid back.
Wow, all moderny!
This prevents the green wee or rusty mess, depending what you run in there.
Cheers, Matt.
Life is far too short not to fill it with what you love. - Jackie French.[/size]
-
PR95
- Posts: 840
- Joined: Tue Mar 24, 2009 11:52 am
- Car(s): PR95 PR20 WASP SWB NH Pajero Superchrged NT Pajero BF SR6 Falcon
- Location: Sunshine Coast QLD
Re: Water problem
Hi Gricey, make sure you have the right radiator cap with the longer reach neck, had this problem years ago and found the cap did not seal the radiator properly.
Re: Water problem
ah yep good point with the long reach caps lads! fell into that trap myself.
new caps are easy to get. CPC brand, part no. 507/07 is the one u want.
coz they only use a 7 pound cap, maybe a new one is in order anyway as this prob mite just be water being pushed out without much pressure in the system?
new caps are easy to get. CPC brand, part no. 507/07 is the one u want.
coz they only use a 7 pound cap, maybe a new one is in order anyway as this prob mite just be water being pushed out without much pressure in the system?
-
gricey
- Posts: 692
- Joined: Wed Feb 24, 2010 9:37 pm
- Car(s): 2 GT Belletts bellett sedan . Florian.gt project.fj Holden. Gemini.lc gtr.datsun240 z
Re: Water problem
Did about 50k on the week end ran with no cap and heater on. Put on a new cap . Seems to have stopes using . Gricey